Step-by-Step Guide to Installing Your Wyze Outdoor Weatherproof Sprinkler Controller Box

For those looking to install the Wyze Weatherproof Sprinkler Controller Box, here are the essential steps to ensure a successful setup. This box is designed to protect your sprinkler controller from the elements, making it ideal for outdoor installations. 1. Preparation: Before starting, ensure the power to your existing sprinkler controller is turned off. Gather the necessary tools, including a power drill with a Phillips head and a 7/32 drill bit, a hammer, a pencil, electrical tape, and wire connector caps. 2. Unpack and Prepare: Remove the weatherproof box from its packaging. Unlock the clips on both sides and take out the accessories. If not already done, unplug the power to your existing controller and take a picture of the wiring for reference. 3. Label and Drill: Use the provided wire stickers to label each wire. Mark the drilling holes with a pencil, ensuring the diameter is 7/32 inches and the depth is 1.575 inches. Use a hammer to tap the anchors into your drywall. 4. Mounting: Secure the weatherproof box to the wall using the screws provided. Ensure the gasket is placed through the housing and the gasket cap is tightened. 5. Wiring: Pull the electric wires through the 1/2" housing on the left and the controller wires through the 3/4" housing on the right. With the power off, connect the electrical wires to the power outlet wires in the box, securing them with connector caps and wrapping them with electrical tape for protection. 6. Final Steps: Reattach the hardwiring bay cover and tighten the screws. Mount the Wyze Sprinkler Controller on the mounting plate, connect the power adapter to an outlet, and close the cover on the weatherproof box, ensuring all clips are locked for complete weatherproofing. By following these steps, you can ensure your Wyze Weatherproof Sprinkler Controller Box is installed correctly and ready to protect your sprinkler system from the elements.